ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
TEST OR INSPECTION
Step 4.Using number one cross-tip screwdriver, unscrew and take out six screws (6).
Take off cover (7). Using multimeter, set to 20 vdc scale. Connect red test lead
to terminal (8) on marker light (9) and black test lead to ground. Check for 11 to
13 vdc on multimeter. Disconnect test leads.
If multimeter does not read 11 to 13 vdc, 58B wire (10) must be
replaced. Notify Direct Support maintenance. Put cover (7) in place,
screw in and tighten six screws (6) using number one cross-tip