ACCESS PROCEDURES - CONTINUED
LOWER CENTER INSTRUMENT PANEL
Batteries must be disconnected before working near electrical components. Failure to observe
this precaution could cause serious injury or damage to equipment.
Disconnect battery cables (page 2-444).
Using cross-tip screwdriver, unscrew and take out 11 screws (1).
Do not pull instrument panel out too far, light bulbs could be pulled from sockets or wires broken.
Open lower center instrument panel (2).
Place lower center instrument panel (2) in position.
Screw in and tighten 11 screws (1) using cross-tip screwdriver.
Connect battery cables (page 2-444).