FUEL TANK SUPPORTS - CONTINUED
Improper cleaning methods and use of unauthorized cleaning liquids or solvents
can injure personnel and cause damage to equipment. Refer to TM 9-247.
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective safety
goggles and gloves and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes and do not breathe vapors. Do not use near open flame or
excessive heat. The flashpoint for type #1 drycleaning solvent is 100°F (38°C) and
for type #2 is 138°F (59C). If you become dizzy while using cleaning solvent, get
fresh air immediately, and get medical aid. If contact with eyes is made, flush your
eyes with water and get medical aid immediately.
Safety goggles must be worn when using wire brush. Flying rust or metal particles
could cause eye injury.
For more information on how to clean parts, go to General Maintenance
Instructions (page 2-424).
Using wire brush, take off dirt and
Clean thoroughly with drycleaning solvent.