EXHAUST PIPE - CONTINUED
INSTALLATION - CONTINUED
Two clamp halves
Put two clamps in position around rear ex-
(2) and hanger
haust pipe and between hanger brackets.
Two clamp halves (2)
Three screws (4),
Position spring on screw.
three nuts (5), and
Screw on and tighten using 9/16-inch
box-end wrench and 9116-inch, 1/2-
inch drive, deep socket and ratchet
Tighten using 7/16-inch box-end wrench.
Metallic hose (9)
Loop clamp (10),
Put loop clamp and saddle in position.
saddle (11), and
Loop clamp must secure connection of
exhaust elbow (12)
metallic hose and exhaust elbow.
Loop clamp (10)
Two nuts (13)
Screw on and tighten using 11/16-inch box-
and two flat