RADIATOR VENT HOSE - CONTINUED
Screw (2), locknut
(3), and clamp (4)
box-end wrench, unscrew, and take out.
Get rid of locknut.
Take clamp off hose (5).
Step 2 is typical for two remaining clamp assemblies.
Radiator shroud (6)
Screw (7), lockwasher
Using 7/16-inch box-end wrench, unscrew, and
(8), and washer (9)
Get rid of lockwasher.
Take clamp off hose.
For more information on how to clean parts, go to General Maintenance Instructions (page 2-424).
Clean with solution of liquid detergent and water.
Rinse in clean water.
Using clean, dry rags, wipe dry.
Replace all damaged or defective parts.
For more information on how to inspect parts, go to General Maintenance Instructions (page 2-
Check for cracks, breaks, chafing, or hardness.
Change 1 2-642.2