TRANSMISSION SHIFT CONTROL - CONTINUED
Put in driving range 1.
Control stand (3)
Put in hole marked during removal.
Screw on and tighten using 112-inch box-
Adapter plate (7)
Shift control cable
Put shift control cable in position.
(8), spacer (9),
Put in spacer and U-bolt.
U-bolt (10), two
Screw on and tighten using 3/8-inch
flat washers (11),
two new lockwashers
Make sure shift control cable is not
(12), and two
being forced to one side If shift
control cable is being forced to one
side, loosen two nuts, adjust, and
Indicator light wire
Aline and push together.
control stand (3)
Make sure indicator light wire (15) is
clear of all moving parts.
Four screws (16) and
Screw in and tighten using 7/16-inch box-
four new lock-
Side cover (18),
Put side cover in place.
four screws (19),
Screw in and tighten using 7/16-inch
and four new lock-