REAR HUB AND BRAKEDRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED
Steps given are typical for right and left front rear and rear rear hubs.
Rear hub (1) and
Coat spindle with grease
With assistance, put on.
Make sure inner bearing is seated on
inner race (7) on spindle.
Outer bearing (8)
Pack outer bearing and coat outer
bearing cup (9) with grease
Adjusting nut (10)
Position with pin (11) facing out and
screw on and tighten until snug.
While slowly turning rear hub (1),
torque to 50 ft lb (70 N.m) using 4-inch,
3/4-inch drive socket and 0 to 600 ft lb
(0 to 814 N.m) torque wrench.
Loosen one-quarter turn using 4-inch,
3/4-inch drive socket and hinged