ENGINE OIL PRESSURE GAGE LINE AND FITTINGS - CONTINUED
REMOVAL - CONTINUED
Use care when removing fittings and flat washer, to prevent damage.
Before removing fittings and flat washer, make sure to note location and position of 45 and 90-degree
elbows, for correct assembly.
25. Engine side of
45-degree elbow (2),
T-fitting (3), 90-
Take off flat washer.
degree elbow (4),
straight pipe fitting
(5), large nut (6),
and flat washer (7)
26. T-fitting (3)
45-degree elbow (2)
Using two 9/16-inch open-end wrenches,
unscrew and take out.
90-degree elbow (4)
Using 1/2-inch and 9/16-inch open-end
wrenches, unscrew and take out.
28. Straight pipe
Using 7/16-inch and 9/16-inch open-end
wrenches, unscrew and take off.
29. Bulkhead fitting (7)
Small nut (8) and
Using 1-inch and 1 1/8-inch open-end
large nut (6)
wrenches, screw on and tighten.