AUXILIARY TRANSMISSION REPAIR (Cont).
Position gear (65) down into case (8) with clutch
teeth of gear facing front of case and outer teeth
of gear meshing with countershaft (71).
Install collar (52) to clutch teeth of gear (65) with extended hub of collar facing gear.
Apply thin coat of grease to surface of mainshaft (49).
Install mainshaft (49) through rear of case (8) and through gear (65).
As mainshaft (49) is Inserted in Case (8), install sleeve (62) and gear (61) to mainshaft.
Ensure that Inner and outer races of
bearing In rear of drive gearshaft remain
As mainshaft (49) is advanced, Install gear (57)
to mainshaft with counterbore In gear facing
front of case (8).
Install collar (58) over gear (57) with extended
hub of collar facing front of case (8).
Position X in. (12.6 mm) thick aluminum or
brass plate between drive gearshaft (33) and