OIL PUMP, FRONT SUPPORT, AND CONVERTER HOUSING REPLACEMENT Cont.
Remove two seal rings (12), thrust bearing (13), and
bearing ring (14) from front support (15). Discard
Remove four of six long bolts (18) holding oil pump
(17) to converter housing (5). Loosen remaining two
long bolts enough to expose some threads.
Wood board is used to cushion oil pump as It falls
free of converter housing.
Position wood board through access hole in side of
converter housing (5).
10 Alternately tap on heads of two remaining long bolts
(18) to loosen oil pump (17).
11 Remove seal ring (16) from oil pump (17).