6-27. TRANSMISSION HOUSING REPAIR (Cont).
Inspect four mounting studs (10) for damage.
Replace if damaged.
Apply thin coat of sealing compound to outer surface of new selector shaft oil seal (8).
Using manual shaft oil seal installer, install selector shaft oil seal (8) in transmission housing (1) with lip of seal
Apply thin coat of hydraulic fluid to surface of manual selector shaft (9), and install manual selector shaft and
inside detent lever (7) with new locknut (6) and retainer pin (5). Torque locknut to 1520 lb.ft. (2027 N.m).
Ensure that pin of Inside detent lever faces inward
toward center of transmission housing.
Apply thin coat of hydraulic fluid to surface of
modulator rod (3) and install modulator rod to
transmission housing (1).
Install plug (4).
Install breather (2).
Install second clutch (see paragraph 6-26).