ENGINE REPLACEMENT (Cont).
Rotate engine only In normal operating direction to prevent damage to engine.
Normal rotation of engine Is clockwise when facing front of engine.
While rotating engine (5) to each of 12 screw (11) positions, remove screws to disconnect flywheel (13) from
engine flexplate (12).
Use extreme caution when handling transmission. Lifting device Is required when parts weigh
over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two person lift, and over 150 lb
(68 kg) for a three or more person lift. Keep clear of heavy parts supported only by lifting device.
DO NOT remove bolts unless transmission Is supported. Failure to follow this warning may result
In serious Injury or death to personnel.
Remove 12 bolts (6) to separate engine (5) from transmission (15).
Perform step 8 at left and right rear engine mounts.
Remove cotter pin, nut, two washers, and bolt from rear engine mount (see paragraph 3-3).
Perform step 9 at left and right front engine mount bracket.
Remove locknut, two washers, and bolt from front engine mount bracket (see paragraph 3-3).