TM 5-3805-264-13&P
0067
INSTALLATION
WARNING
Use extreme care when handling heavy parts. Lifting cables, chains, hooks, and slings
must be in good condition and of suitable capacity. Keep clear of parts supported only by
lifting device. Failure to comply may result in personnel injury, death, and/or damage to
equipment.
NOTE
Use antiseizing tape on all pipe threads (WP 0072).
1.
Attach a nylon sling and suitable lifting device to hydraulic reservoir (Figure 2, Item 1). Take up slack in
sling.
2.
Position hydraulic reservoir (Figure 2, Item 1) on cylinder support frame (Figure 2, Item 15).
3.
Install four screws (Figure 2, Item 6), washers (Figure 2, Item 7), new lockwashers Figure 2, Item 8),
spacers (Figure 2, Item 9), and new locknuts (Figure 2, Item 10). Torque locknuts to 100 to 110 lb-ft
(136 to 149 Nm). Remove nylon sling.
4.
Install elbow (Figure 2, Item 14) and hose barb (Figure 2, Item 13) on hydraulic reservoir (Figure 2, Item 1).
5.
Connect suction hose (Figure 2, Item 12) to hose barb (Figure 2, Item 13) and tighten clamp
(Figure 2, Item 11).
6.
Install tee (Figure 2, Item 3) with oil sampling valve (Figure 2, Item 4) on filter housing (Figure 2, Item 2).
7.
Connect hydraulic return hose (Figure 2, Item 5) to tee (Figure 2, Item 3).
0067-4
03/15/2011Rel(1.10)root(maintwp)wpno(M1004126413)