Solvent Cleaning Compound
DA PAM 750-8
These instructions are mandatory.
Lubrication of M917A1, M917A1 with Material Control System (MCS), M917A2,
and M917A2 with MCS chassis is in TM 9-2320-363-10 or TM 9-2320-302-10 and
TM 9-2320-363-20-1, TM 9-2320-363-20-2, TM 9-2320-302-20-1, or
The M917A1, M917A1 with MCS, M917A2, and M917A2 with MCS Dump Body must receive lubrication with
approved lubricants at recommended intervals in order to be mission-ready at all times.
Hydraulic oil/filter are changed by Field Maintenance annually.
The Lubrication Chart shows lubrication points, items to be lubricated, the required lubricants, and recommended
intervals for lubrication. Any special lubrication instructions required for specific components are contained in the
NOTES section of the chart.
The KEY provides information needed to select the proper lubricant for various temperature ranges and uses, and
identifies the capacities and intervals.
Recommended intervals are based on normal conditions of operation, temperature, and humidity. When operating
under extreme conditions, lubricants should always be changed more frequently. When in doubt, notify your
SPECIFIC LUBRICATION INSTRUCTIONS
Keep all lubricants in a closed container and store in a clean, dry place away from extreme heat. Keep container
covers clean and do not allow dust, dirt, or other foreign material to mix with lubricants. Keep lubrication
equipment clean and ready for use.
Maintain a record of lubrication performed and report any problems noted during lubrication. Refer to
DA PAM 750-8 for maintenance forms and procedures to record and report any findings.
Keep all external parts of equipment not requiring lubrication free of lubricants. After lubrication, wipe off excess
lubricant to prevent accumulation of foreign matter.