TM 5-3805-264-14&P
4-73.
HYDRAULIC RESERVOIR REPLACEMENT (Cont).
2.
3.
4.
5.
6.
Remove tee (2) with oil sampling valve (3)
from filter housing (1).
Loosen clamp (10) and disconnect suction
hose (11) from hose barb (12).
Remove hose barb (12) and elbow (13) from
hydraulic reservoir (15).
Attach a nylon sling and suitable lifting device
to hydraulic reservoir (15). Take up slack in
sling.
Remove four locknuts (9), spacers (8), lock-
washers (7), washers (6), and screws (5). Dis-
card locknuts and lockwashers.
7.
Use extreme caution when handling
heavy parts. Keep clear of heavy
parts supported only by lifting
device. Failure to follow this warn-
ing may cause injury to personnel
or damage to equipment.
Remove hydraulic reservoir (15) from cylinder
support frame (14).
Clean and inspect components in accordance with Chapter 4, Section III, General Maintenance Instruc-
rions.
4-137