NOTES:
1. ARMY OIL ANALYSIS PROGRAM (AOAP).
6. ENGINE FULL FLOW OIL FILTER. Filter
element is to be replaced each time an engine oil
For Active Army units, obtain samples from engine
change is directed by AOAP laboratory. After
and automatic transmission every 500 miles
installing new filter element, fill crankcase, operate
(805 km) of operation or 60 days (whichever comes
engine for five minutes, check housing for leaks,
first). Reserve and National Guard activities will use
check crankcase oil level, and bring to "H" (high)
500 miles (805 km) or 120 days as the prescribed
mark on dipstick. When AOAP support is not
sample intervals. Reserve and National Guard
available, install new filter element each 1000 miles
equipment in frequent use during active training
period will adhere to the schedule for Active Army
(1609 km).
units. As a minimum, one sample from each item of
7. ENGINE AUXILIARY OIL FILTER. Filter
equipment will be submitted for each units' two
element is to be replaced each time an engine oil
week active training period. Send these samples to
change is directed by AOAP laboratory. After
the nearest AOAP laboratory. Refer to TB 43-0210 for
installing new filter element, fill crankcase, start
sampling instructions. When or if AOAP laboratory
engine, and loosen vent plug in cover. Tighten vent
support is unavailable, hard time intervals will apply.
plug when oil appears at plug. Operate engine for
NOTE
five minutes, check housing for leaks, check
crankcase oil level, and bring to "H" (high) mark on
Do not hold ON samples. Submit oil
l
dipstick. When AOAP laboratory support is not
samples as soon as they have been taken.
available, install new filter element each 1000 miles
(1609 km).
Seasonal oil changes will be made due to
l
expected temperatures (see Key).
8. POWER STEERING PUMP FILTER. Each
2. FOR OPERATlON OF EQUIPMENT IN
10,000 miles (16,090 km), drain power steering
PROTRACTED COLD TEMPERATURES BELOW
reservoir, remove cover plate, filter element, and
clean inside of reservoir with lint-free cloth. Install
Key for temperatures above -10F (-23%).
new filter element and replace cover. Fill reservoir to
Relubricate with lubricants specified in Key for
indicated level or 1 in. (3.8 cm) below top of filler
temperatures below -10F (-23%). If OEA lubricant
neck on reservoir. With engine running, turn wheels
is required to meet the temperature ranges
from left to right and continue filling until the proper
prescribed in the Key, OEA lubricant is to be used in
level is maintained. When operating in dusty areas,
place of OE/HDO-10 lubricant for all temperature
replace filter element more often.
ranges where OE/HDO-10 Is specified in the Key.
CLEANER
STRAINER
9. AIR
(AIR
3. OIL CAN POINTS.
Each 2500 miles
(4023 km), lubricate transmission remote control
remove strainer from air cleaner. Clean strainer, oil
linkage, pivot pins, sliding surfaces, accelerator
lightly with OE/HDO-30, and install in air cleaner.
linkage, door hinge pins, cab latch, pedal-to-brake
When operating under extreme dusty conditions,
valve linkage, butterfly-type hood hinge, and all
service strainer more often.
exposed adjusting threads with OE/HDO-10.
10. WATER PUMP AND FAN HUB. Each 10,000
NOTE
miles (16,090 km), remove pipe plugs, install
When OEA oil is used, oil level should be
fittings, lubricate with a shot (tablespoon full) of
checked more often.
GAA, and install pipe plugs.
4. ENGINE OIL LEVEL HOT OR COLD CHECK.
11. FORWARD-REAR AND REAR-REAR AXLE
Cold engine, oil level should be at "H" (high) mark
on dipstick. Hot engine, oil level must be between
(16,090 km), remove wheels, clean and inspect all
"H" (high) and "L" (low) marks on dipstick (allow to
parts, and replace damaged or worn parts. Repack
set five minutes before checking).
bearings, assemble, and adjust bearings.
5. ENGINE CRANKCASE. Oil is to be changed
each time an engine oil change is directed by AOAP
12. FORWARD-REAR AND REAR-REAR AXLE
laboratory. When AOAP laboratory support is not
BRAKE CHAMBER. Each 5000 miles (8045 km),
available, change oil every 1000 miles (1609 km).
add 2 oz (59 cc) of OE/HDO-10 through air inlet port
Drain when lubricant is warm.
at each brake chamber to lubricate seal.
TA701869
LO 5-3805-254-12
CARD 7 OF 8
