TM 5-3805-254-20-1
ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
a. If multimeter reads no continuity, 8 wire (4) must be replaced. Notify
Direct Support Maintenance.
b. If multimeter reads 0 ohms, clean wire terminal (6) and circuit
breaker terminal stud (2) using wire brush. Place wire terminal (6)
in position and screw nut (5) on to circuit breaker terminal stud (2)
and tighten using 1/2-inch open-end wrench. Connect batteries
(page 2-424) and go to step 11.
TA243752
2-53
