TM 5-3805-254-20-2
REAR BRAKES - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
CLEANING - CONTINUED
WARNING
Parts of the service brake assembly will be coated with asbestos dust Breathing this dust may be hazardous to your health
Use a filter mask approved for use against asbestos dust Never use compressed air or dry brush to clean these
assemblies Dust shall be removed using an industrial-type vacuum cleaner with a high-efficiency filter system.
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-424).
27
Upper dust shield
a
Clean using drycleaning solvent and
(1), lower dust
cleaning brush.
shield (2), and
b
Wipe clean using wiping rag.
brake spider (3)
28
Brake camshaft (4)
a
Clean using drycleaning solvent and
cleaning brush.
b
Wipe clean using wiping rag.
WARNING
Safety goggles must be worn when using wire brush Flying rust and metal particles can cause eye injury.
29
Upper and lower
a
Clean off rust and scale using wire
anchor pins (5) and
brush.
brake rollers (6)
b
Wipe clean using drycleaning solvent
and wiping rag.
30
Camshaft bracket (7)
a
Clean inside and outside using dry-
cleaning solvent and cleaning brush.
b
Wipe clean using wiping rag.
31
Slack adjuster (8)
a
Clean spline and outside surfaces using
drycleaning solvent and cleaning brush.
b
Wipe clean using wiping rag.
2-962
