TM 5-3805-254-34
3-3.
ENGINE MOUNTS REPLACEMENT (Con’t)
CAUTION
Ensure that engine mounts at front of
engine are In place, or that engine Is
fully supported with suitable lifting
device, before attempting to remove
rear mounting brackets.
NOTE
Perform steps 4 through 7 to remove
rear engine mounts and brackets.
4.
Support rear of engine (4) with suitable lifting
device.
5.
Raise rear of engine (4) just enough to take
weight of engine off rear engine mount upper
Insulator (16).
NOTE
Perform steps 6 through 8 at left and
right rear of engine.
6.
Remove cotter pin (20), nut (19), washer (21),
bolt (10), washer (11), Insulator (22), and upper
insulator (16) from rear engine mount (23).
Discard cotter pin.
7.
Remove four bolts (15), lockwashers (14),
washers (13), and rear engine mounting bracket
(12) from engine (4). Discard lockwashers.
8.
Remove four bolts (24), nuts (18), and rear
engine mount (23) from frame (17).
b.
INSTALLATION
Perform steps 1 through 3 to Install rear engine mounts and brackets at left and right rear of engine.
1.
Install rear engine mount (23) on frame (17) with four bolts (24) and nuts (18).
2.
Install rear engine mounting bracket (12) to engine (4) with four washers (13), new lockwashers (14), and bolts
(15).
3.
Install rear engine mounting bracket (12) to rear engine mount (23) with insulator (22), upper insulator (16),
washer (11), bolt (10), washer (21), nut (14), and new cotter pin (20).
4.
Remove lifting device and tighten bolts (10).
TA703656
3-14
