TM 5-3805-254-34
12-2.
LEFT POWER STEERING GEAR REF
NOTE
Ensure that each valve seat Is flush with or slightly below end surface of piston.
2.
Install spring (40), two balls (39), two valve seats
(38), and two washers (37) in piston (28).
NOTE
Ensure that plug Is Installed until flush
with end of piston, then rotate plug until
locking pin can be Installed through
piston and plug. Ensure that plug and
locking pin are flush with or slightly
below end surface of piston.
3.
Install plug (42) and locking pin (41) in piston
(28).
4.
Install valve positioning pin (36) to side of piston
(28).
NOTE
Piston rings that have a taper on one
side or are marked TOP are Installed
with taper or marking facing outward
toward end of piston. Piston rings not
tapered or marked may be Installed In
either direction.
5.
Install two piston rings (29) on piston (28).
6.
Coat spool (35), reversing Spring (34), and actuating valve (33) with oil and Install spool, reversing spring, and
actuating valve In piston (28).
7.
Coat reversing spring (31), bearing nut (30), and locking pin (32) with oil and install reversing spring, bearing nut,
and locking pin In piston (28).
TA704021
12-10
