TM 5-3805-264-14&P
Section II. SERVICE UPON RECEIPT
Paragraph
Number
Paragraph Title
Page
Number
4-4.
4-5.
4-6.
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-2
Inspection Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-2
Servicing Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-2
4-4.
GENERAL.
When a new, used. or reconditioned M917A1 or M917A1 w/MCS is first received, determine whether it
has been properly prepared for service and is in condition to perform its mission. Follow the inspection instructions
in paragraph 4-5 and servicing instructions in paragraph 4-6.
4-5.
INSPECTION INSTRUCTIONS.
a.
Read and follow all instructions on DD Form 1397.
b.
Remove all straps plywood, tape, seals wrapping, or any other shipping material.
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective gog-
gles and gloves, and use only in a well-ventilated area. Avoid contact with skin,
eyes and clothes, and DO NOT breathe vapors. DO NOT use near open flame or
excessive heat. The solvents flash point is 100°F-138°F (38°C-59°C). If you become
dizzy while using cleaning solvent, immediately get fresh air and medical help. If
solvent contacts eyes, immediately wash your eyes and get medical aid.
If any exterior parts are coated with rust preventive compound, remove with dry cleaning solvent
(Item 18, Appendix F) and rags (Item 15, Appendix F).
d.
Inspect the equipment for any damage incurred during shipment. Also check to see if the equip-
ment has been modified.
e.
Check the equipment against the packing slip to ensure that the shipment is complete. Report any
discrepancies.
4-6.
SERVICING INSTRUCTIONS.
a.
Perform all Unit maintenance PMCS. Schedule the next PMCS on DD Form 314.
b.
Perform all lubrication regardless of interval, as described in Lubrication Instructions, Chapter 3,
Section I.
c.
Report any problems on DA Form 2404.
4-2