ENGINE OIL PRESSURE GAGE LINE AND FITTINGS - CONTINUED
ASSEMBLY - CONTINUED
Make sure 45 and 90-degree elbows are assembled in same position and location as noted in removal.
43. T-fitting (1)
Screw in and tighten using 1/2-inch and
9/16-inch open-end wrenches.
Screw in and tighten using two 9116-inch
45. Bulkhead fitting (4)
Flat washer (5)
Small nut (6)
Turn small nut until a few threads can be
seen on T-fitting side of bulkhead.
47. Engine side of
Put into bulkhead fitting hole.
(4), small nut (6),
flat washer (5),
straight pipe fitting
(8), T-fitting (1),
45-degree elbow (3),