SECTION I
INTRODUCTION
1-1.
SCOPE
The instructions in this supplemental operating, maintenance and repair parts instructions (SOMARPI) are for:
a.
The user of the 20 Ton Dump Truck.
b.
Maintenance personnel responsible for maintaining and/or re pairing the Dump Truck.
c.
Supply personnel responsible for requisitioning and stockage of repair parts.
1-2.
MILSTRIP REQUISITION IDENTIFICATION AND CONTROL
a.
Parts Requisition Identification and Control
(1)
A combination of Project and Weapon System Codes will be used for identification and controls of CCE
parts requisitions. Three (3) CCE Project Codes and a unique Army Weapon System Designator Code (WSDC) are
assigned to the CCE Dump Truck.
(2)
The purpose and intended use of the CCE Project Code is to identify manufacturer's part numbered items
to the Defense Construction Supply Center (DCSC) for the action DCSC will take in support of the CCE Plan. A CCE
Project Code will be used on all non-NSN requisitions and routed to DCSC. The CCE Project Code will have a. two-fold
meaning: (1) to identify the requisition to a specific CCE end item, and (2) to identify the routing of parts shipments either
by the Direct Support System (DSS) procedures, or by non-DSS procedures. National Stock Numbered (NSN) items
identified in the initial recommended Prescribed Load List and Authorized Stockage List (PLL/ASL) as well as non-stocked
NSN items will use the standard supply system and DSS assigned codes when applicable, on the requisition.
(3)
The WSDC will be used on all parts requisitions (NSN or non-NSN) submitted for support and will be used
in conjunction with the Logistics Intelligence File (LIF) in accumulation of Demand/Consumption, Life Cycle Costing
Analysis and to provide and overview of the CCE Plan for reporting and analysis.
1
