TM 5-3805-254-20-1
ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
f
If battery connector cables (4) are not loose, corroded, frayed, or broken and batteries
are charged, go to step 6.
Step 6
Check battery negative (-) cable (3) connection at frame rail (8) for loose or corroded condition.
a
If battery negative (-) cable (3) is loose, tighten screw (9) and nut (10) using 3/4-inch,
1/2-inch drive socket, ratchet handle and 3/4-inch open-end wrench.
b
If battery cable terminal (11) is corroded, unscrew screw (9) and nut (10) using 3/4-
inch, 1/2-inch drive socket, ratchet handle and 3/4-inch open-end wrench, and take
off battery cable terminal (11). Clean battery cable terminal (11) and frame rail (8)
mating surface using wire brush. Place screw (9) and battery cable terminal (11) in
position and screw on and tighten nut (10) using 3/4-inch, 1/2-inch drive socket,
ratchet handle and 3/4-inch open-end wrench.
c
If battery negative (-) cable (3) is not loose or corroded, go to step 7.
2-89
