TM 5-3805-254-20-1
ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 4.
Check 62J wire (11) on junction box (12) as follows: Using 9/16-inch open-end wrench, unscrew
and take off air line fitting (13). Using number two cross-tip screwdriver, unscrew and take out six
screws (14) and six flat washers (15). Take off lower rear molding (16). Check 62J wire (11) for
loose or frayed condition.
a. If 62J wire (11) is loose, tighten nut (17) using 3/8-inch open-end wrench. Put lower
rear molding (16) in place. Screw in and tighten six screws (14) and six flat washers
(15) using number two cross-tip screwdriver. Screw on and tighten air line fitting (13)
using 9/16inch open-end wrench.
b. If 62J wire (11) is frayed, it must be replaced. Notify Direct Support Maintenance.
2-313
