TM 5-3805-254-20-1
ENGINE AUXILIARY OIL FILTER SHELL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
CLEANING
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective safety goggles and gloves
and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes and do not
breathe vapors. Do not use near open flame or excessive heat. The flashpoint for type #1
drycleaning solvent is 100 °F (38 °C) and for type #2 is 1380F (59 °C). If you become dizzy while
using cleaning solvent, get fresh air immediately, and get medical aid. If contact with eyes is
made, flush your eyes with water and get medical aid immediately.
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-424).
7.
All metal parts
Clean using drycleaning solvent and wiping rag.
INSPECTION/REPLACEMENT
NOTE
Replace all damaged or defective parts.
For more information on how to inspect parts, go to General Maintenance Instructions (page 2-
424).
8.
All metal parts
a.
Check for cracks, breaks, or other damage.
b.
Look for excessive rust or corrosion.
9.
All threaded parts
Look for damaged threads or rounded heads.
INSTALLATION
10.
Cab firewall (1)
Oil filter mounting
Put in place.
bracket (2)
11.
Two nuts (3), four
Screw in and tighten using 9/16-inch box-end
washers (4), and
wrench and 9/16-inch open-end wrench.
screws (5)
12.
Oil filter mounting
Oil filter mounting
Put in place.
bracket (2)
bracket (6)
Change 1 2-465.10