TM 5-3805-254-20-1
PREHEATER PRIMER PUMP FUEL LINES AND FITTINGS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
47.
Bulkhead fitting (1)
Flat washer (2)
a. Put washer on bulkhead fitting.
and nut (3)
b.
Turn nut until a few threads can be
seen on tee fitting side of nut.
CAUTION
Use care when installing bulkhead fitting, outlet fuel line, and fuel pressure gage fuel line.
Damage to fuel lines nearby or wiring could occur.
NOTE
Fuel pressure gage fuel line, tagged as PRESSURE GAGE-8 must be positioned to right of tee
fitting when installed behind dashboard.
48.
Rear of dash-
Bulkhead fitting (1)
Put in.
board (4)
49.
Firewall (5)
Bulkhead fitting (1)
Put washer on bulkhead fitting. -
and flat washer (6)
NOTE
Assistance will be required to perform steps 50 and 51.
50.
Nut (3)
Using 1 1/8-inch open-end wrench, hold
nut from moving.
51.
Bulkhead fitting (1)
Nut (7)
Screw on and tighten using 1-inch deep,
1/2-inch drive socket, 6-inch extension and
ratchet handle.
2-502
