TM 5-3805-254-20-2
FRONT REAR OF CAB JUNCTION BOX - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSPECTION/REPLACEMENT
NOTE
Replace all damaged or defective parts.
For more information on how to inspect parts, go to General Maintenance Instructions (page 2-424).
6.
Junction box (1)
Look for cracks, breaks, or corrosion.
7.
All threaded parts
Look for damaged threads or rounded
heads.
INSTALLATION
8.
Junction box
Junction box (1)
a.
Put junction box in place. See table
support (2)
and two nuts (3)
below.
b.
Screw on and tighten using 7116-inch
box-end wrench.
9.
Junction box (1)
Nineteen wires (4)
a.
Put wires in place.
and twelve new self-
b.
Screw on and tighten using 3/8-inch
locking nuts (5)
box-end wrench.
c.
Take off tags.
d.
Get rid of tags.
10.
Left side rear cab
Air line (7) and
a.
Push air line through hole in molding.
wall (6)
left lower rear
b.
Put molding in place.
molding (8)
11.
Left lower rear
Eight flat washers
Screw in and tighten using number two
molding (8)
(9) and eight
cross-tip screwdriver.
screws (10)
12.
Driver seat valve
Air line (7) and
a.
Put line in place.
assembly (11)
line nut (12)
b.
Screw on and tighten using 9/16-inch
open-end wrench.
2-782
