TM 5-3805-254-202
LOWER INSTRUMENT PANEL OPTICAL RIBBON
This task covers:
a.
Removal (page 2-864)
b.
Installation (page 2-866)
INITIAL SETUP
Tools
Personnel Required
Screwdriver, cross-tip, number one
One
Screwdriver, flat-tip, 118-inch
Screwdriver, flat-tip, 1/4-inch
Equipment Condition
Wrench, box-end, 7/16-inch
(two required)
Battery cables disconnected (page 2-424).
Left side cab door opened (page 2-424).
Materials/Parts
Lower center instrument panel opened
(page 2-424).
Lockwasher, power take off control
to lower center instrument panel
(two required)
ACTION
LOCATION
ITEM
REMARKS
3. Two screws (10) and a.
Using number one cross-tip screw-
REMOVAL
NOTE
Steps given are typical for removal of three identification tabs from three bezels.
1. Rear of instrument
Bezel (2) and iden-
a. Using 1/8-inch flat-tip screwdriver, pry
panel (1)
tification tab (3)
rear of bezel back and take out identifi-
cation tab.
b. Take out bezel.
c. Repeat step a until all three identification
tabs and bezels have been removed.
2. Lower center instru-
Power take off
a. Using two 7/16-inch box-end wrenches,
ment panel (4)
control (5), two
unscrew and take off.
screws (6), two flat
b. Take off power take off control.
washers (7), two
Do not remove screws from lower
lockwashers (8), and
center instrument panel.
two nuts (9)
c. Get rid of lockwashers.
2-864