TM 5-3805-254-20-2
RIGHT INSTRUMENT PANEL OPTICAL RIBBON
This task covers:
a
Removal (page 2-860)
b
Installation (page 2-862)
INITIAL SETUP
Tools
Personnel Required
Screwdriver, cross-tip, number one
One
Screwdriver, flat-tip, 1/8-inch
Screwdriver, flat-tip, 1/4-inch
Equipment Condition
Wrench, box-end, 7/16-inch (two
required)
Battery cables disconnected (page 2-424).
Left side cab door opened (page 2-424).
Materials/Parts
Lower center instrument panel opened
(page 2-424).
Lockwasher, power take off control to
Right instrument panel opened (page 2-424).
lower center instrument panel (two
required)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
Steps given are typical for removal of four identification tabs from four bezels.
1
Rear of instrument
Bezel (2) and iden-
a
Using 1/8-inch flat-tip screwdriver, pry
panel (1)
tification tab (3)
rear of bezel back and take out identifi-
cation tab.
b
Take out bezel.
c
Repeat step a until all four identification
tabs and bezels have been removed.
2
Lower center instru-
Power take off
a
Using two 7/16-inch box-end wrenches,
ment panel (4)
control (5), two
unscrew and take off.
screws (6), two
b
Take off power take off control.
flat washers (7),
Do not remove screws from lower
two lockwashers (8),
center instrument panel.
and two nuts (9)
c
Get rid of lockwashers.
2-860
