TM 5-3805-254-20-2
FRONT RELAY VALVE TO FRONT REAR T-FITTING HOSE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-424).
3.
Airhose
Clean using liquid detergent and wiping rag.
INSPECTION/REPLACEMENT
NOTE
Replace all damaged or defective parts.
For more information on how to inspect parts, go to General Maintenance Instructions (page 2-424).
4.
Airhose
a.
Check for cracks, breaks, chafing, or
hardness.
b.
Look for excessive rust or corrosion.
5.
All threaded parts
Look for damaged threads or rounded
heads.
INSTALLATION
CAUTION
Antiseizing tape must be used on all pipe threads to provide a good seal and to prevent threaded parts
from seizing.
NOTE
For more information on how to use antiseizing tape, go to General Maintenance Instructions (page 2-
424).
6.
Front rear
45-degree elbow (2)
Wrap pipe threads with antiseizing tape.
T-fltting (1)
7.
45-degree elbow (2)
Screw on and tighten using 7/8-Inch open-
and line nut (3)
end wrench.
8.
Front relay
90-degree elbow (5)
Wrap pipe threads with antiseizing tape.
valve (4)
9.
90-degree elbow (5)
Screw on and tighten using 7/8-inch open-
and line nut (6)
end wrench.
Change 1 2-1100
