TM 5-3805-254-20-2
FRONT HUB AND BRAKEDRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSPECTION/REPLACEMENT - CONTINUED
22
Brakedrum (1)
Position on wood blocks with hub studs
facing up.
WARNING
Safety goggles must be worn to prevent eye injury from flying metal chips when using compressed air, or
striking metal surfaces.
23
Front hub (2)
Hub stud (3)
Using 3-pound cross-peen hammer, drive
out.
NOTE
If brakedrum or front hub is to be replaced, replace before performing following step.
24
Brakedrum (1) and
a
Put brakedrum onto front hub.
front hub (2)
b
Position on wood blocks with brakedrum
facing up.
c
Aline hub stud holes.
25
Brakedrum (1)
Hub stud (3)
a
Put into hub stud hole.
b
Drive in using 3-pound cross-peen
hammer and brass driftpin punch.
Make sure hub stud is flush against
brakedrum
TA244440
2-1182
