TM 5-3805-254-20-2
OIL RESERVOIR - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
CLEANING
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective safety goggles and
gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes
and do not breathe vapors. Do not use near open flame or excessive heat. The
flashpoint for type #1 drycleaning solvent is 100F (38C) and for type #2 is 138°F (59C).
If you become dizzy while using cleaning solvent, get fresh air immediately, and get
medical aid. If contact with eyes is made, flush your eyes with water and get medical aid
immediately.
Improper cleaning methods and use of unauthorized cleaning liquids or solvents can
injure personnel and cause damage to equipment. Refer to TM 9-247.
NOTE
All parts must be cleaned thoroughly.
For more information on how to clean parts, go to General Maintenance Instructions
(page 2-424).
10.
All parts
Using drycleaning solvent, clean
thoroughly.
WARNING
Particles blown by compressed air are hazardous. Make certain the air stream is directed
away from user and other personnel in the area. Compressed air used for cleaning
purposes shall not exceed 30 psi (207 kPa). User must wear safety goggles or face
shield to prevent injury to personnel.
11.
All parts
Using air blow gun and air hose assembly,
blow dry.
INSPECTION/REPLACEMENT
NOTE
Replace all damaged or defective parts.
For more information on how to inspect parts, go to General Maintenance Instructions
(page 2-424).
12.
Reservoir (1)
Look for bends, dents, or cracks.
2-1240
