TM 5-3805-254-20-2
WIPER BLADE AND ARM - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
2.
Driver shaft (1)
Acorn nut (2) and
a.
Using 5/8-inch box-end wrench, un-
wiper arm (3)
screw and take off.
b.
Using 12-inch pinch bar, pry off.
3.
Wiper arm (3)
Driver nut (4)
Using 3/8-inch flat-tip punch and 12-ounce
hammer, tap out.
4.
Wiper arm (3) to
Screw (6) and
Using 1/4-inch, 1/4-inch drive socket and
wiper blade (5)
nut (7)
ratchet handle and 1/8-inch flat-tip screw-
driver, unscrew and take off.
5.
Wiper arm (3)
Wiper blade (5)
Take off.
INSTALLATION
6.
Wiper arm (3)
Wiper blade (5)
Place in position.
7.
Wiper arm (3) to
Screw (6) and
Screw on and tighten using 1/4-inch, 1/4-
wiper blade (5)
nut (7)
inch drive socket and ratchet handle and
1/8-inch flat-tip screwdriver.
8.
Driver shaft (1)
Driver nut (4)
Place into position.
9.
Wiper arm (3)
Place into position.
10.
Wiper arm (3) to
Acorn nut (2)
Screw on and tighten using 5/8-inch box-
driver shaft (1)
end wrench.
]
ADJUSTMENT
NOTE
Make sure air pressure is approximately 70 psi (482.3 kPa) for correct adjustment.
11.
Wiper arm (3) to
Acorn nut (2)
Using 5/8-inch box-end wrench, unscrew
driver shaft (1)
and take off.
12.
Driver shaft (1)
Wiper arm (3)
Using 12-inch pinch bar, pry off.
13.
Wiper arm (3)
Driver nut (4)
Using 3/8-inch flat-tip punch and 12-
ounce hammer, tap out.
2-1302
