TM 5-3805-254-34
5-8.
JACOBS EXHAUST BRAKE WIRING HARNESS REPLACEMENT (Cont).
4.
Remove two screws (10) and clamps (9) from engine covers (4).
5.
Disconnect three connectors (2) from engine connections (3).
6.
Note location of 12 tie-down straps (8) to assist in installation and remove tie-down straps securing harness
assemblies (6 and 7). Discard tie-down straps.
7.
Remove harness assemblies (6 and 7) from vehicle.
NOTE
Keep wires of harness assembly being replaced to use as a template to make new harness
assembly.
8.
If replacing either harness assembly (6 or 7), remove all connectors (1) and terminal lugs (5 and 11) from harness
to be replaced.
b.
INSTALLATION
NOTE
Perform steps 1 through 3 only if replacing harness assembly.
1.
Use wires from old harness assembly (6 or 7) as a template and cut new wires to same length.
TA703731
5-40