TM 5-3805-254-34
6-2.
AUXILIARY TRANSMISSION REPAIR
22.
Remove speedometer drive gear (51) and
washer (50) from rear of mainshaft (49).
NOTE
Perform steps 23 and 24 to expose
retainer ring at front of mainshaft.
23.
Pull drive gearshaft (33) with bearing (53) fully
forward.
24.
Drive mainshaft (49) forward until collar (52)
contacts rear of drive gearshaft (33).
NOTE
Perform either step 25 or 26 to
remove retainer ring from front of
mainshaft.
25.
Pry retainer ring (54) upward to remove retainer
ring. Discard retainer ring.
26.
Press downward on ends of retainer ring (54) and allow retainer ring to drop into bottom of case (8). Discard
retainer ring.
27.
Using two pry bars, move mainshaft (49) assembly to rear of case (8).
28.
Using puller attached to snapring of ball bearing
(56), remove ball bearing from case (8). Discard
ball bearing.
29.
Remove
thrustwasher
(55).
Discard
thrustwasher.
30.
While pulling mainshaft (49) through rear of case
(8), remove collar (58), gear (57), sleeve (59),
gear (61), bearing (60), sleeve (62), collar (52),
gear (63), gear (65), and bearing (64) out
through top of case (8). Discard bearings.
31.
Remove drive gearshaft (33) through top of case
(8).
32.
Remove outer race of bearing (53) from drive
gearshaft (33). Discard outer race.
33.
Remove
bearing
(66)
from
rear
of
drive
gearshaft (33). Discard bearing.
6-12
