TM 5-3805-254-34
6-40.
GEAR UNIT REPAIR (Con’t).
NOTE
Perform
steps
11
through
14
to
assemble FRONT planetary carrier.
11.
Install cone (12) into each of six pinion gears
(11).
NOTE
For easier assembly, planetary pins may be cooled and front planetary carrier may be heated.
12.
Position one pinion gear (11), two bearing
washers (9), and two bearing seats (10) into
front planetary carrier (4) and press in one new
piston pin (8). Install end of pinion pin to 0.117-
0.127 in. (2.97-3.3 mm).
13.
While supporting pinion pin (8) on X in. (12.7
mm) diameter anvil, swage each end of pinion
pin in eight places using suitable punch. After
swaging, pinion gear (11) must freely rotate.
14.
Repeat steps 12 and 13 for five remaining
pinion gears (11).
TA703911
6-196
