TM 5-3805-254-34
6-41. CENTER SUPPORT REPAIR.
This Task Covers:
a. Disassembly
c. Assembly
b. Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
Center support removed (see paragraph 6-24).
Hydraulic fluid (Item 7. Appendix B)
Tools/Test Equipment:
Grease (Item 10, Appendix B)
Dry cleaning solvent (Item 23, Appendix B)
· General mechanic's tool kit
Two seal rings
· Field automotive shop set
Four seals
· Installer
Eight push-on nuts
General Safety Instructions:
Dry cleaning solvent is flammable and must not be used near open flame. Use only in a well-ventilated area.
a. DISASSEMBLY
1. Place center support (1) on work surface with
hub of center support facing upward.
2. Remove two seal rings (2) from hub of center
support (1). Discard seal rings.
TA703916
6-201
