TM 5-3805-254-34
6-41. CENTER SUPPORT REPAIR (Con’t).
c.
ASSEMBLY
1.
Install bearing race (11) and roller bearing (10)
on hub of center support (1).
2.
Place center support (1) on work surface with
hub of center support facing downward.
3.
Using center support (1) to hold piston (4), place
piston into center support until fully seated.
4.
Install 20 springs (7) into recesses of piston (4).
5.
Install spring retainer (6) over springs (7).
6.
Using installer, install four new push-on nuts
(5).Press
downward
until
flange
of
spring
retainer (6) bottoms in recess of center support
(1).
7.
Remove piston (4) from center support (1).
8.
Turn center support (1) over and repeat steps 3
through 7 to assemble piston (4) on other side of
center support.
9.
Apply thin coat of hydraulic fluid to surface of
center support (1).
10.
Apply thin coat of grease to new seals (8 and 9).
11.
With spring side of piston (4) facing downward, install seals (8 and 9) with lips of seals facing upward.
TA703919
6-204
