TM 5-3805-254-34
7-1.
PROPELLER SHAFT AND UNIVERSAL JOINT REPLACEMENT (Con’t).
b. INSTALLATION
NOTE
All propeller shafts and universal joints are installed in same way.
Perform following steps at each universal joint.
1.
Install lubrication fitting (14) in slip yoke (5).
2.
Press slinger (11) on flange (4).
3.
Install flange (4), washer (12), and nut (13) on shaft (10).
4.
Depending on which propeller shaft is replaced, tighten nut (13) to following torque:
At rear of transmission (15) to 750-1000 lb.-ft. (1017-1356 N m).
At each end of auxiliary transmission (16) to 500-550 lb.-ft. (678-746 N m).
At either differential (17) to 300-400 lb.-ft. (407-542 N m).
5.
Install lubricator (9) to tee (8).
6.
Install slip yoke or propeller shaft with new tee (8), four new seal retainers (7), and new trunnion seals (6).
TA703924
7-3
