TM 5-3805-254-34
15-25. WINDSHIELD GLASS REPLACEMENT (Con’t).
b.
INSTALLATION
1.
On flat surface with forward surface of two windshields (1) facing downward, install new dividing weatherseal (2)
between edges of windshields.
2.
Install new weatherseal (4) around outside edge of windshields (1) with lip of weatherseal facing upward.
3.
Press twine into groove of weatherseal (4) with excess twine meeting at bottom of dividing weatherseal (2). Use
care to keep twine straight and free of kinks.
4.
Apply detergent and water solution to groove of weatherseal (4).
5.
Position two windshields (1) to outside windshield opening of cab with excess twine inside cab.
NOTE
Hold both sides of twine to prevent twine from pulling free of weatherseal before
lip of weatherseal is fully over windshield opening.
6.
While pressing two windshields (1) against windshield opening of cab, pull one end of twine half-way around
windshield opening to raise lip of weatherseal (4) over windshield opening of cab.
7.
While pressing two windshields (1) against windshield opening of cab, pull other end of twine half-way around
windshield opening to fully install windshields and weatherseal (4).
8.
Press around outside of weatherseal (4) to ensure that weatherseal is fully seated in windshield (1) opening of
cab.
TA704172
15-66
