TM 5-3805-254-34
15-26. CAB REAR GLASS REPLACEMENT (Con’t).
b.
INSTALLATION
1.
Install new weatherseal (2) around edge of rear glass (1).
2.
Press twine (3) into groove of weatherseal (2) with excess twine meeting at bottom of weatherseal. Use care to
keep twine straight and free of kinks.
3.
Apply detergent and water solution to groove of weatherseal (2).
4.
Position rear glass (1) on outside of rear glass opening with excess twine (3) inside cab.
5.
Have assistant press rear glass (1) against rear glass opening from outside of cab.
NOTE
Hold both sides of twine to prevent twine from pulling free of weatherseal
before lip of weatherseal Is fully over rear glass opening.
6.
Pull one end of twine (3) half-way around rear glass (1) to raise lip of weatherseal (2) over rear glass opening.
7.
Pull other end of twine (3) half-way around rear glass (1) opening to fully install rear glass and weatherseal (2) in
rear glass opening.
8.
Press around outside of weatherseal (2) to ensure that weatherseal is fully seated in rear glass (1) opening.
9.
Wipe rear glass (1), weatherseal (2), and rear glass opening free of detergent and water solution.
10.
Apply rubber cement to any areas of weatherseal (2) that appear not fully seated. Wipe off excess rubber cement.
FOLLOW-ON TASKS:
Lower dump body (see TM 5-3805-254-10).
15-69
