TM 5-3805-264-13&P
0072
TUBES AND COMPRESSION FITTINGS - Continued
Twist inverted nut into compression fitting and tighten inverted nut against compression sleeve with open-
end wrench. Compression sleeve will clamp down around tube and conform to internal surface of
compression fitting and inverted nut.
Repeat previous two steps for other end of tube as required.
Figure 3. Tubes and Compression Fittings.
END OF TASK
FLUID DISPOSAL
WARNING
When servicing this vehicle, performing maintenance, or disposing of materials such as
engine coolant, transmission fluid, lubricants, battery acids or batteries and CARC paint,
consult your unit/local hazardous waste disposal center or safety office for local regulatory
guidance. If further information is needed, please contact the Army Environmental Hotline
at 1-800-872-3845. Failure to comply may result in personnel injury, death, and/or damage
to equipment.
END OF TASK
SERVICE REPLACEMENT PARTS AND KITS
Many service replacement parts are available in standard sizes as well as various undersized and/or oversized
sizes. Service kits for reconditioning certain parts and service sets, which include all parts necessary to complete
a procedure, are also available.
END OF TASK
03/15/2011Rel(1.10)root(maintwp)wpno(M1005226413)