TM 5-3805-264-13&P
0073
NOTES:
1.
CARGO COVER.
a.
Semiannually, remove chain cover. Clean chain as required and lubricate sparingly with corrosion
preventive. Install chain cover (WP 0055).
b.
Semiannually, lubricate roller shaft bearings at roll-up bar mounting brackets. Apply corrosion
preventive sparingly.
2.
TRANSPORT LOCK LINKAGE.
a.
Monthly, raise dump body and support on body props (WP 0005). Apply GAA to four lubrication fittings
on linkage. Remove dump body from body props and lower.
b.
Remove locking pin and operate transport lock. Reinstall locking pin with transport lock at 3 o'clock
position (WP 0005).
3.
HYDRAULIC RESERVOIR.
WARNING
To prevent burns, use caution when removing fill cap of hydraulic reservoir when
hydraulic fluid is hot. Avoid contact with hot hydraulic oil. Use extreme care when
filling, sampling or draining hydraulic oil. Failure to comply may result in personnel
injury.
a.
Daily, with dump body down, vehicle parked on level ground, and engine off, check sight tube to
determine level of hydraulic oil in reservoir. Level should be even with FULL mark on oil level decal. If
low, remove fill cap, remove any debris from strainer, and clean fill cap and strainer with a clean rag.
Add OE/HDO or OEA through fill cap opening to bring oil level up to FULL mark. DO NOT overfill.
NOTE
If reservoir must be filled while dump body is raised and supported on body
props, level of oil should be at bottom of sight tube.
Whenever hydraulic oil filter service indicator shows RED, hydraulic oil filter
element must be replaced.
b.
Annually, with dump body down, remove cap from drain tube on underside of reservoir and drain all
oil. Remove and clean fill cap and strainer. Install strainer (WP 0064). Replace hydraulic oil filter
element (WP 0063). Clean drain plug and install. Fill reservoir with OE/HDO or OEA until level in sight
tube is at FULL mark on oil level decal. DO NOT overfill.
4.
STABILIZER. Monthly, raise dump body and support on body props (WP 0005). Apply GAA to five
lubrication fittings on stabilizer. Remove dump body from body props and lower.
5.
TAILGATE HINGE PINS. Monthly, apply GAA to each tailgate hinge pin lubrication fitting.
6.
TAILGATE LOCKING LINKAGE. Monthly, apply GAA to tailgate locking linkage lubrication fitting.
7.
BODY PROPS. Semiannually, raise dump body and support on body props (WP 0005). Apply GAA to each
body prop lubrication fitting.
END OF WORK PACKAGE
0073-9/blank
03/15/2011Rel(1.10)root(lubewp)wpno(M1005326413)
