TM 5-3805-264-14&P
Section IV.
UNIT PREVENTIVE MAINTENANCE CHECKS
AND SERVICES (PMCS)
Paragraph
Number
Paragraph Title
Page
Number
4-28.
4-29.
4-30.
4-31.
4-32.
4-33.
Table 4-1.
4-34.
Table 4-2.
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Explanation of Table Entries. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
General Lubrication Procedures. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
General PMCS Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PMCS Initial Setup. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lubrication Data. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lubrication Data. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Mandatory Replacement Parts. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Unit Preventive Maintenance Checks and Services (PMCS) for M917A1 and
M917A1 w/MCS Body . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-13
4-13
4-14
4-15
4-16
4-17
4-17
4-18
4-19
4-28.
GENERAL.
NOTE
Refer to TM 9-2320-363-20 for Unit PMCS for the dump truck chassis.
To ensure that the dump truck body is ready for operation at all times, it must be lubricated and inspected
on a regular basis so that defects may be found before they result in serious damage, equipment failure, or injury to
personnel. Table 4-1 lists the types, amounts, and temperature ranges of the lubricants required for specified inter-
vals. Table 4-2 contains systematic instructions on lubrications inspections. adjustments, and corrections to be
performed by Unit Maintenance to keep your equipment in good operating condition and ready for its primary mis-
sion.
4-29.
EXPLANATION OF TABLE ENTRIES.
a.
Item Number (Item No.) Column. Numbers in this column are for reference. When completing
DA Form 2404 (Equipment Inspection and Maintenance Worksheet), include the item number for the check/service
indicating a fault. Item numbers also appear in the order you must perform checks and services for the interval
listed.
b.
Interval Column. This column tells you when you must perform the procedure in the procedure
column.
(1)
Semiannual procedures must be done once every six months
(2)
Annual procedures must be done once each year.
c.
Location. Item to Check/Service Column. This column identifies the location and the item to be
checked or serviced.
4-13