TM 5-3805-274-13&P
0045
INSTALLATION
1.
Lift and install hoist cylinder (Figure 4, Item 1) on subframe (Figure 4, Item 9).
2.
Attach lifting sling around hoist cylinder (Figure 4, Item 1).
3.
Using fork lift or other lifting device, support hoist cylinder (Figure 4, Item 1).
4.
Allow hoist cylinder (Figure 4, Item 1) to rest against hydraulic reservoir tank until installation of bottom
mount is complete.
5.
Using suitable drift and hammer, install lower hoist pin (Figure 4, Item 3) in mounting bushings
(Figure 4, Item 2). Access hole is provided in subframe (Figure 4, Item 9) to insert lower hoist pin
(Figure 4, Item 3) and drift.
6.
Slide collars (Figure 4, Items 5 and 11) on lower hoist pin (Figure 4, Item 3).
7.
Install screws (Figure 4, Items 6 and 12) and nuts (Figure 4, Items 4 and 10) on collars
(Figure 4, Items 5 and 11).
8.
Install hydraulic hose (Figure 4, Item 7) on fitting (Figure 4, Item 8) at bottom of hoist cylinder
(Figure 4, Item 1).
9.
Raise dump body bed (Figure 5, Item 1) and lower safety strut (Figure 5, Item 2) to stowed position.
10.
Remove suitable lifting device from lifting eyes on dump body bed (Figure 5, Item 1).
11.
Using suitable drift and hammer, install upper hoist cylinder pin (Figure 6, Item 9) in mounting bushings
(Figure 6, Item 10).
12.
Install collars (Figure 6, Items 7 and 12) on ends of upper hoist cylinder pin (Figure 6, Item 9) with
screws (Figure 6, Items 8 and 11) and nuts (Figure 6, Items 6 and 13).
13.
Install access covers (Figure 6, Items 2, 3, and 4) on dog house (Figure 6, Item 5) with six screws
(Figure 6, Item 1).
14.
Remove filler cap from hydraulic reservoir tank and fill hydraulic reservoir tank to center of bottom sight
glass indicators.
15.
Start engine and engage PTO (TM 9-2320-273-10). Check for oil leaks, recheck oil level at top sight
glass indicators, and shut down engine.
0045-4
