TRUCK SERVICE MANUAL
AXLE-REAR
B. Remove the inter-axle differential cover cap
screws and lock washers and lift the assembly
from the carrier.
C. Remove input shaft nut and washer.
I. Remove side gears, spider and pinion assembly
and thrust washers.
D. Press inter-axle differential assembly from cover.
J. Remove differential bearings from case halves
with suitable puller.
DISASSEMBLE INTERAXLE (3rd) DIFFERENTIAL
ASSEMBLY
A. Remove input shaft cotter key using a suitable
NOTE: Inner bearing cone and spacer will remain on
holder for flange or yoke. Loosen nut, but do not
input shaft. Retain spacer for rebuild.
remove at this time.
IMPORTANT: Oil seal assembly and
outer bearing will remain in interaxle
differential cover. Do not remove unless
necessary.
E. If original identification marks are not clear, mark
the differential case sections with a punch or
chisel for correct alignment during reassembly.
28