TM 5-3805-254-20-1
ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 26.
Set multimeter to ohms scale and adjust to 0 ohms. Connect red test lead to output terminal (10) on
KEY SWITCH (9) and black test lead to input terminal (8) on ENGINE START button (2). Check for 0
ohms on multimeter. Disconnect test leads.
a.
If multimeter reads no continuity, 17 wire (11) must be replaced.
Notify Direct Support Maintenance.
b.
If multimeter reads 0 ohms, go to step 27.
TA243778
2-101
