TM 5-3805-254-20-1
ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
b. If 50 wire (6) is corroded, unscrew and take off nut (8) and wire terminal (9) using 3/8-
inch open-end wrench. Using wire brush clean wire terminal (9). Place wire terminal
(9) in position and screw nut (8) on to circuit breaker terminal (10) and tighten using
3/8-inch open-end wrench.
c. If 50 wire (6) is frayed, repair (page 2-424).
d. If 50 wire (6) is broken, 50 wire (6) must be replaced. Notify Direct Support
Maintenance.
e. If 50 wire (6) is not loose, corroded, frayed, or broken, go to step 19.
2-183
