TM 5-3805-254-20-1
ENGINE AUXILIARY OIL FILTER HOSES AND FITTINGS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
CAUTION
Antiseizing tape must be used on all pipe threads to provide a good seal and to prevent threaded
parts from seizing.
NOTE
For more information on how to use antiseizing tape, go to General Maintenance Instructions
(page 2-424). See tags for correct location of hoses.
15.
Engine oil pump (1)
Bushing (2)
a.
Wrap pipe threads with antiseizing tape (page
2-424).
b.
Screw in and tighten using 7/8-inch open-end
wrench.
16.
Bushing (2)
90-degree elbow (3)
a.
Wrap pipe threads with antiseizing tape (page
2-424).
b.
Screw in and tighten using 5/8-inch open-end
wrench.
17.
Left side of engine (4)
90-degree elbow (5)
a.
Wrap pipe threads with antiseizing tape (page
2-424).
b.
Screw in and tighten using 5/8-inch open-end
wrench.
18.
90-degree elbow (5)
Line nut (6)
Screw in and tighten using 3/4-inch open-end
wrench.
19.
90-degree elbow (3)
Line nut (7)
Screw in and tighten using 3/4-inch open-end
wrench.
NOTE
Step 20 is typical for three clamp assemblies.
20.
Extension (8)
Clamp (9), new locknut
a.
Put clamps (9) on hose (12) and hose (13).
(10), and screw (11).
b.
Screw in and tighten using 1/2-inch box-end
wrench and 7/16-inch open-end wrench.
Change 1 2-465.4
